12'' Wall Mounted Rain Shower System 3-Function Shower Combo Set with 6 Body Spray Jets in Matte Black,Rough-in Valve Included

I rehab houses for a living and was little worried about what kind of quality but wasimpressed with the product. Would absolutely order again.

Pros - All of the pieces are brass and standard US fitting sizes (1/2" NPT)Great finish and quality - Using wrenches with a towel covering them seemed to allow a good fit to tighten and not damage the fixturesLooks absolutely great and works nicelyCons - The escutcheons for the body sprays are not very large (and square). Drilling round holes in the tile must be VERY exact. Buy the correct color caulk for finishing work as it's virtually impossible to get these perfect (at least for me).The holder for the sprayer isn't tapered, so it's not very positive. It works, but it seems like a little oddComments - There is 1 pg of installation instructions that are not very thorough. In reality, you only need a quick schematic of what needs attached to the body valve (5- 1/2" fittings. One for hot water in, one for cold water in, one for the shower head out, one for the sprayer out, one for the body jets out). The outer knobs are for hot and cold. The center knob rotates 360 for each function and do not operate at the same time. I mounted mine horizontally instead of vertically due to shower design.Use a pressure balancing loop for the body jets.I used 3/4" supply lines for everything but that's because I already had 3/4" throughout the house. If possible, go this route for the body jets. I don't think 1/2" lines would provide a proper effect but have no proof to support this as I only used 3/4".If using 3/4" line, thing about furring out the wall to 5 1/2" rather than a standard 3 1/2" studded wall. Depending on how you need to run lines, it might become very cumbersome to run lines centrally through the wall if you have a vent pipe to contend with or other supply lines to a sink or toilet as I did.The body jets come with 1" nipples that are removable. I have no idea how you'd place a fitting inside the tile, flush to the finished wall to accommodate that short length AND keep the hole size small enough for the escutcheon to cover it properly. I recommend placing your 1/2" female NPT fittings securely in the wall, tile over with holes cut properly, and then remove the nipples form the body jets when it's time to install. There is a convenient hex fitting inside the nipples for easy removal . Go to your local plumbing shop and find the correct length. I happened to use 3" but it'll completely depend on your installation depth. It's a cheap fix and works very well once you stop trying to figure out how to use the short nipples that were pointless for my installation process.

This piece adds to an amazing bathroom.

I’m not going to lie and say it was easy to install. My contractor took 3 days to set it up because the instructions were not helpful at all. But when he finally got it, I can honestly say I’m in heaven!!! I love my shower and body jets. This was a great upgrade, and worth the money. The fixtures were well made, heavy sturdy pieces. It’s worth the money if you can find the right person install it because it was not easy.

I’m sure this is a nice product but my wife didn’t want black fixtures......TOO BAD!!!

Do not buy this product. It is uneven and professional plumbers refuse to install it.

Was extremely pleased with the shipment time product appeared as what was showed installed it today in a master shower. I just received the install instruction after I sent a request a few months back. If anything wrong I would just encourage to put the diagram with shipment. Overall I’m happy and will purchase again and will recommend to others as well. 👍🏾👍🏼👍

Great back massage